The choice of wear-resistant ceramics is 92% alumina wear-resistant ceramic liners. There is no recursion, protrusions, peeling and debonding and poor adhesion around the construction of the wear-resistant ceramic liner. Defects such as sky layer and debonding, and the quality standards required by customers are completely consistent.

　　Before construction, clean the surface of the steel plate to remove impurities, dust and rust to make the surface of the steel plate appear metallic. After that, samples were cut according to the specific specifications of the charcoal bucket and the specifications of the ceramics. After finishing these post-processing, wear-resistant ceramic liner will be attached.

　　Stick the mixed adhesive evenly on the surface of the board and the wear-resistant ceramic base material, and then move it in one direction to ensure that there will be no gel, colloid, bubbles and deposition. Then, according to the actual situation of ceramic paste, the ceramics are modified and cut twice to minimize the gap and smooth the surface.

　　Weld the wear-resistant ceramic liner to the steel, then cover the ceramic sleeve and fix it with glue.